MRS-3 (Master resetting 3)
Master resetting 3 requires the entry of Serial No. data in addition to
Master resetting 1.
After completion of the MRS-3, the following operations and program-
ming will be inhibited.
1. GT programming.
2. All memory download via RS-232.
3. GT resets with Z report. (Z report can be made, but GT will not be
reset.)
Procedure
1) Turn off the AC switch.
2) Set the reset switch to the "SRV" position.
3) Turn on the AC switch.
4) While holding down the JOURNAL FEED key and MRS-3 key,
turn to (SRV) position from (SRV’) position.
MRS-3 key : UP-600=[CANCEL] key
UP-700=[PLU70] key
5) The product serial No. input window is displayed as shown
below.
DISPLAY:
Enter the product serial No. of this POS and enter the [CA/AT]
key.
6) Key position assignment:
After the execution of MRS-2, only the RECEIPT FEED and
JOURNAL FEED keys can remain effective on key assignment.
Any key can be assigned on any key position on the main key-
board.
[key setup procedure]
MASTER RESET
NOTES:
*1: When the 0 key is pressed, the key of the key number on
display is disabled.
*2: Push the key on the position to be assigned. With this, the key
of the key number on display is assigned to that key position.
*3: When relocating the keyboard, the PGM 1/2 mode use stand-
ard key layout.
Key
No.
Key
name
Key
No.
Key
name
Key
No.
Key
name
001
011 021
002 012 022
003 013 023
004 014
005 015
006 016
007 017
008 018
009 019
010 020
SERIAN No. 00000000
MRS-2 executed Key position set Free key
Disable
Free key setup
complete.
*2
*1
0
0
>>>>> USE FONT <<<<<
Helvetica/ Helvetica-Condensed/ Century-Schoolbook/ Symbol & OriginalFonts: (RingWorld2/RingFont2/Pa
Symbol/PartsCod)
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
To Next Page
Loading...
Need help?
General
