CONNECTIONS PREPARATIONS
Connecting Aerial Cable to VCR
Connecting to a Stereo TV
..
.. I I
TV ANTENNA IN
Connecting Antenna Cable to VCR
NOTES:
• Audio recorded in the EP mode in the NTSC system is not recorded on the
Hi-Fi track, but on the linear track.
• If you simultaneously switch both the TV and the VCR to the AV mode after
connecting as in the diagram above, the audio and video may be distorted.
Accordingly, do not switch both to the AV mode simultaneously.
-
1-
_
--
~
r-
q
::
I~
~u;
Imt
~
_m.
~
~
..
-<0-
From
RFOUT
I--
From From
From VIDEO OUT
AUDIO IN RlL AUDIO OUT RlL
From VIDEO IN
ToAUDIO OUT R/L
-I···
,
--
- - - -_...-
To VIDEO
otrr
To VIDEO IN
To AUDIO IN RlL
To ANTENNA IN
-
•
t
TV back panel
VCR rear
ANTENNA IN
1
1
/ TV back panel
ANTENNA IN
Connected to outdoor or indoor
antenna
or
cable
Disconnect the aerial cable from the
back of your TV set.
Disconnecting·TV Cable
Connect the supplied coaxial cable to
the RF
OUT
terminal
of
the VCR.
Plug the
other
end
into
your
TV's
ANTENNA IN terminal.
NOTE:
When the connection is made using
the
RF
OUT
terminal,
stereo
or
bilingual sound will not be output.
Connect the antenna cable to the TV
ANTENNA IN terminal of your VCR.
Connecting VCR to TV
[§]
6
To Next Page
Loading...
