Sharp VC-MH703HM

8
If problems persist contact the SHARP Helpline on tel: 0990-274277
INSTALLING YOUR VCR
INSTALLATION CONTINUED
The clock setting screen will now appear.
To set the time and date follow the steps
below:
1.
Press the [ / ] menu select
buttons to select either 12 or 24 hour
clock operation.
2.
Press [ / ] to select TIME. Enter
the time using the
NUMBER
BUTTONS
or the [ / ]
buttons. If the minutes or hours are
less than 10, enter the leading 0. If
using the 12 hour clock enter AM or
PM by pressing the
AM/PM
button on the remote control.
3.
Press [
/
] to select DATE. Enter
the date using the
NUMBER
BUTTONS
or the [ / ]
buttons. For example, for 1st April
enter
01 04
.
4. Press [
/
] to select YEAR. Enter
the last two digits of the year using
the
NUMBER BUTTONS
or the
[ / ] buttons. For example, for
2000 enter
00
. For the year 2001
enter
01
.
5. Press the
SET
button to store the time
and date.
NOTE:
✔
All the programmes should now be correctly tuned in and the clock set.
• You will need to update the clock for Winter/Summer daylight saving.
12 hour example:
24 hour example:
CLOCK
MODE T I ME DATE YEAR
24H 15:0501/0400
MODE : 2 4H / 12H
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
CLOCK
MODE T I ME DATE YEAR
12H 03:05PM 01/04 00
MODE : 2 4H / 12H
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
AM/PM
TINS-3776 ENGLISH.book Page 8 Thursday, May 25, 2000 4:18 PM