29
If problems persist contact the SHARP Helpline on tel: 0990-274277
Remote Control
Station
Signals
VHF
Real
Channel
Numbers
A
B
C
D
E
F
G
H
J
01
02
03
04
05
06
07
08
09
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
• It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1.
Press
MENU
.
2.
Press the [ / ] menu select buttons
to select SET UP. Press
SET
to confirm.
3.
CHANNEL PRESET will be
highlighted. Press
SET.
4. Press [ / ] to select CHANNEL.
5. VC-MH713LM/VC-M303LM only
IMPORTANT NOTE:
Press to select CH or CC. This will
determine whether off air (CH) or cable
(CC) is tuned first. Note that both off air
and cable will be tuned regardless of the
setting.
6. Press [/] to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press
[/] to continue tuning.
7. Press [ / ] to select FINE
TUNING. Press and hold [/]until
the sharpest colour picture is obtained.
IMPORTANT NOTE:
8. If you connect an independent decoder,
you must press [ / ] to select
DECODER, then select
[/] to turn
the decoder function ON.
9. Press [ / ] to select SKIP.
The SKIP function determines whether the
channel can be selected when using the
CHANNEL / instead of the
NUMBER BUTTONS.
10. Press [/] to select ON or OFF for
this option.
11. Press SET to confirm.
12. Press MENU to leave this function.
CHANNEL PRESET
CHANNEL SORT
CLOCK
➔
PRESET 1
CHANNEL CH 2 1
FINE TUNING
▲
▲
DECODER ON OFF
SKIP ON OFF
CABLE RECEPTION
VC-MH713LM/VC-M303LM
only
MENU SET
CLEAR
DISPLAY
PLUSCODE
MODE OSD
ON/OFF
OUT
SEARCH
BACK
231
TINS-3776 ENGLISH.book Page 29 Thursday, May 25, 2000 4:18 PM
To Next Page
Loading...
