18
If problems persist contact the SHARP Helpline on tel: 0990-274277
BASIC OPERATION
HOW TO CHECK, CHANGE AND CANCEL A DELAYED
RECORDING
Before you start!
• If appears on the VCR display, press TIMER ON/OFF to remove the symbol.
CHECKING A RECORDING
1. Press STOP to switch on the VCR.
2. Press MENU.
3. Press [ / ]to select TIMER. Press SET to
confirm.
• All the delayed recordings in the VCR’s memory
will be shown.
4. If the settings are correct press MENU to exit.
• If you wish to change or cancel any settings,
follow the procedures below.
CHANGING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING.
2. To change a delayed recording, press
[ / ] to highlight the recording, then press
SET to select.
3. Press [/] to highlight the setting to be
changed and correct it by using the [ / ]
or the
NUMBER BUTTONS.
4. When all corrections are complete press SET to
confirm, then press
MENU to exit.
CANCELLING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING.
2. To cancel a delayed recording, press
[ / ] to highlight the recording to be
cancelled, then press
CLEAR.
3. Press MENU to exit.
NOTE:
• If there are some programmes to be recorded, do not forget to press TIMER ON/OFF
button to return the VCR to TIMER STANDBY mode.
MENU SCREEN
TIMER
MOD E
SET UP
: SELECT
SET : ENTER MENU : EX I T
1/2
DATE PR START STOP
21/060212:0013:00SP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
1/2
DATE PR START STOP
21/060212:0013:00SP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
TINS-3776 ENGLISH.book Page 18 Thursday, May 25, 2000 4:18 PM
To Next Page
Loading...
