Sharp VC-MH711GM

10
BASIC OPERATION
IMMEDIATE RECORDING
SELECTION OF A CHANNEL
Select the channel by using the number buttons on the remote control, or select the next/
previous channel by pressing
CHANNEL [K or L].
To change between single digit and 2-digit channel numbers, press .
For example, for channel 24, press then press
2 4.
You can record the channel you are watching or a different channel.
1. Insert a video tape into your VCR.
2. Select the channel you wish to record on the VCR.
3. To start recording, press REC (Æ).
4. To pause during recording, press PAUSE/STILL (II).
5. To continue recording, press REC (Æ).
6. To stop recording, press STOP (r) once.
SIMPLE TIMED RECORDING:
1. To specify a stop time, press RECORD (Æ).
2. Each additional press of RECORD (Æ) will
delay the stop time by 10 minutes.
3. To stop recording at any time, press STOP (r)
once.
NOTES:
• If the tape ends before the recording is complete the VCR will stop recording and
rewind.
• If the VCR ejects the video tape when you press
REC (Æ) the tape is record protected.
i.e. record protection tab has been removed.
STOP 15:30