24
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
Normally it will not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
Ensure the video channel is selected on the TV.
1.
Press
MENU
.
2.
Press [
K
/
L
] to select SET UP. Press
SET
to confirm.
3.
CHANNEL PRESET
will be
highlighted. Press
SET
.
4.
Press [
K
/
L
] to select
CHANNEL
.
5.
Press to select CH or CC. This will
determine whether off air (CH) or cable
(CC) is tuned first. Note that both off air
and cable will be tuned regardless of the
setting.
6. Press [H/J] to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press [
H/J] to continue tuning.
7. Press [K/L] to select FINE TUNING.
Press and hold [
H/J] until the sharpest
colour picture is obtained.
9. Press [K/L] to select SKIP. The SKIP function determines whether the channel can be
selected when using the
CHANNEL K/L instead of the NUMBER BUTTONS.
Press [
H/J] to select ON or OFF for this option.
10. Press SET to confirm.
11. Press MENU to leave this function.
IMPORTANT NOTE:
8. If you connect an independent decoder, you must press [K/L] to select DECODER,
then select [
H/J] to turn the decoder function ON.
INSTALLATION
CHANNEL PRESET
CHANNEL SORT
CLOCK
LANGUAGE
➔
PRESET 1 ARD1
CHANNEL CH2 1
FINE TUNING
▲
▲
DECODER ON OFF
SKIP ON OFF
To Next Page
Loading...
