29
CUSTOMISED INSTALLATION
CHANGING THE ON-SCREEN DISPLAY LANGUAGE
Changing the language used by the on-screen display will not change the operation of the
VCR or make it suitable for any other broadcast standard.
1. Press MENU.
2. Press [K/L] to select SET UP. If the display is
not in a language you can understand, this is
the fourth option from the top. Press
SET to
confirm.
3. Press [K/L] to select LANGUAGE (the last
option).
4. Then press SET to confirm.
5. Press [K/L / H/J] to select your language. Then press SET to confirm. Press MENU to
return to a normal screen.
MANUALLY SETTING THE CLOCK
The clock will normally be set using teletext information when your VCR automatically tunes in
the broadcast channels. If for any reason teletext signals are not present your VCR will not be
able to set the clock. This procedure will allow you to set the clock manually.
1. Press MENU. Press [K/L] to select SET UP.
Press
SET to confirm.
2. Press [K/L] to select CLOCK. Press SET to
confirm.
3. Press [K/L] to select either 12 or 24 hour
clock.
4. Press [H/J] to select TIME. Enter the time using
the
NUMBER BUTTONS or [K/L]. If the minutes are less than 10, enter the leading
0. If using the 12 hour clock enter AM or PM by pressing on the remote control.
5. Press [H/J] to select DATE. Enter the date using the NUMBER BUTTONS or
[
K/L]. For example, for 1st April enter 01 04.
6. Press [H/J] to select YEAR. Enter the last two digits of the year using the NUMBER
BUTTONS or [K/L]. For example, for 2002 enter 02. For the year 2003 enter 03.
7. Select * for AUTO CLOCK on/off (* is ON, - is OFF). Then press SET to confirm.
NOTE:
• If AUTO CLOCK is set to OFF (- is OFF) then you will need to update the clock for
daylight saving.
To Next Page
Loading...
