Sharp VE-CG40U

Advanced Features
52
Advanced Features
Setting to Factory
Presettings
Available in w, [, ], ;, ', , or . mode
You can set the camera to the factory preset-
ting by following the steps below.
1 Turn on the camera in the desired mode.
2 Press the MENU button until the menu
screen appears.
3 Press l or m to select “Z”, then press
the SET button.
4 Press l or m to select “DEFAULT”,
then press the SET button.
5 Press l or m to select “YES”, then
press the SET button.
• Select “NO” to cancel the procedure.
Formatting the card
Available in w, [, ], ;, ', , or . mode
Format any commercially available card before
using. Also, you may have to format a card that
has been used in a different camera. Be aware
that formatting a card erases all the stored
images.
Notes:
• Formatting a card erases all stored images,
including delete-protected images. Be sure to
backup important data on your computer or
other media before formatting the card.
• Do not remove the power source during
formatting, as this may cause damage to the
card. It is recommended that you use the AC
outlet for the power supply when formatting.
1 Turn on the camera in the desired mode.
2 Press the MENU button until the menu
screen appears.
3 Press l or m to select “Z”, then press
the SET button.
4 Press l or m to select “FORMAT”, then
press the SET button.
5 Press l or m to select “YES”, then
press the SET button.
• Select “NO” to cancel card format.
6 Press the MENU button to turn off the
menu screen.
Note:
• The supplied card is preformatted for immediate
use.
FORMAT
AUTO OFFPOWER
F I L E NUMB ER
RETURN
DEFAULT
SETTING 1
YES
NO
ALL WI LL
DEFAULT
SETT INGS
RETURN FACTORYTO
OK?
SETTINGS.
AUTO OFFPOWER
F I L E NUMB ER
RETURN
DEFAUL T
SETTING 1
FORMAT
YES
NO
ALL WI LL BE
FORMAT
IMAGES
DELETED!
OK?
VE-CG40U-051-059 02.8.27, 7:34 PM52