Sharp ViewCam VL-WD250S

Preparation
Preparation
13
MENU/DISPLAY button
Power switch
Operation button
LCD monitor OPEN
release button
DISPLAY
SETT I NG
12H 24H
CLOCK SET
SETT I NG
000
:
1 2001.1.
DISPLAY
SETT I NG
12H 24H
CLOCK SET
000
:
1 2001.2.
SETT I NG
000
:
6 2001.2.
SETT ING
Setting the Date and Time
Example: Setting the date to 2 June 2002 (2. 6.
2002) and the time to 10:30 am (10:30).
Note:
• Before performing the procedure below, make
sure that the lithium battery has been installed
(see page 11).
1 Press the LCD monitor OPEN release
button (1) and open the LCD monitor
(2).
2 Hold down the Lock button
and set the Power switch to
CAMERA.
4 Press r on the Operation button.
5 Press d or y (1) to select “2” (day),
and then press r (2).
Lock button
6 Press d or y to select “6” (month),
and then press r.
0 00
:
SETT ING
6 2002.2.
10 00
:
SETT ING
6 2002.2.
10 30
:
SETT ING
6 2002.2.
7 Press d or y to select “2002” (year),
and then press r.
8 Press d or y to select “10” (hour),
and then press r.
9 Press d or y to select “30” (minute),
and then press e.
• The internal clock now starts operating.
10 Press the MENU/DISPLAY button to
turn off the menu screen.
3 Press the MENU/DISPLAY button until
the menu screen appears.
DISPLAY
SETT I NG
12H 24H
CLOCK SET
SETT I NG
000
:
1 2001.1.