Sharp VL-E610S

VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
3-2
5. Pulling the lens holder, and pull out the lens upwards. Then, remove the lens connector.
Note:
Be careful so as not to damage the FPC since the camera
PWB unit is connected to the lens unit with the FPC
attached.
7. Remove the camera PWB unit and the lens unit together, opening two claws of the battery holder outward.
Lens holder
Lens connector
Pull out
6. Remove one connector and two screws ((b)LX-HZ0018TAFF) and pull out the lens unit from the tilt frame C.
Connector
Pull out
(b)
(b)
Tilt frame C
Claw
Claw
Open
Remove
Remove
Open