Sharp VL-E610S - Page 7

VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
3-3
3-2. Disassembly of the VCR main body
1. Removal of the VCR lid shaft
(1)Remove one screw ((j)LX-HZ0063TAFC).
Area A
(2)Bring the jig (example: slotted precision screwdriver) into contact with the removal groove of the VCR lid shaft, and slide
the screwdriver with care to prevent injuring the VCR lid and frame V.
Frame V
VCR lid shaft
VCR lid
(3)Pull out the VCR lid shaft head which projects beyond the surface of the VCR lid.
VCR lid shaft
2. Disassembly of the cabinet L
(1)Slide the “VCR lid knob” in the arrow direction, and slide the VCR lid in the arrow direction as far as the cabinet L
fastening screw is visible. (Left figure) Since the connector of the microphone is still connected, take care to prevent
excessively sliding the VCR lid.
VCR lid
(2)Remove five screws ((b)LX-HZ0018TAFF).
(b)
(j)
VCR lid knob
Detail of area A