Sharp VL-PD1U - Tape Running Adjustment; Adjustment Locations and Height Adjustment

VL-PDI U
8. TAPE RUNNING ADJUSTMENT
8-1 m Adjustment locations
I I
<Replacement parts>
. S guide
. T roller, arm
- Tu guide, arm
- Slide chassis
Adjust the height of only
replaced parts with the
adjusting jig.
Adjustment procedure 8-2
-
. Ball base
- Guide roller
. Drum assembly
- Cap motor, etc.
Cassette controller
3
installation
8-2. Running height adjustment
After replacement of S guide, T roller or Tu guide adjust the height . (Adjust only the replaced parts.)
After height adjustment do not turn the T roller. If crease is found on the tape of S guide and Tu guide, remove the crease
by rotating. (As for details refer to the “running rough adjustment”.)
S guide
/
T roller
Tu guide
Lower edge
fitting
Height setting jig
\ Master plane
After setting adjustment jigs, turn T roller
and S guide counterclockwise to 135’.