VL-SDPOU
SHARI=
SERVICE MANUAL
S79K7VL-SD20U
LIQUID CRYSTAL DIGITAL CAMCORDER
NTSC
MODEL VL-SD20U
In the interests of user-safety (Required by safety regula-
tions
in
some
countries) the set should be restored
to
its
original condition and only parts
identical to those specified
be used.
J
/-
CONTENTS
Page ’
1 . IMPORTANT SERVICE NOTES.. .................................................................................................... l-l
2. SPECIFICATIONS
........................................................................................................................... 2-1
3. PART NAMES.. ................................................................................................................................ 3-l
4. DISASSEMBLY OF THE SET
........................................................................................................
.4-l
5. MECHANISM ADJUSTMENT JIGS AND PARTS
..........................................................................
.5-l
6. INSPECTION AND MAINTENANCE
ITEMS AND INTERVALS
............................................................................................................... .6-l
7. MECHANICAL ADJUSTMENTS AND CHECKS
............................................................................
.7-l
8. TAPE RUNNING ADJUSTMENT
..................................................................................................... 8-l
9. MECHANICAL SECTION ASSEMBLY AND PARTS REPLACEMENT
(DISASSEMBLY AND REASSENBLY).
.........................................................................................
.9-l
lO.ADJUSTING THE ELECTRICAL CIRCUITS
.................................................................................
10-l
11 .USEFUL TIPS ................................................................................................................................ 1 l-l
12.SIGNAL FLOW DIAGRAMS .......................................................................................................... 12-1
13.BLOCK DIAGRAMS ...................................................................................................................... 13-l
14SCHEMATIC DIAGRAMS
..............................................................................................................
14-1
15SEMICONDUCTOR LEAD IDENTIFICATION
...............................................................................
15-1
1 G-PRINTED WIRING BOARD ASSEMBLIES
...................................................................................
16-1
17.REPLACEMENT PARTS LIST
.......................................................................................................
17-1
18.PACKlNG OF THE SET.. ............................................................................................................... 18-l
SHARP CORPORATlON
This document has been published to be used for
after sates service only.
The contents are subject to change without notice.
To Next Page
Need help?
General
