VL-SD20U
9-5. Reassembly
9-5-l. Reassembly in side of the main chassis.
Note) Numbers before part names are given as a guide to the order of assembly.
As for greasing/oiling/cleaning places refer to the attached drawings (Grease/Oil application Fig. 1, 2).
1.
Groove grease
(2) Pinch drive lever
(1) Pinch control lever
Main chassis assembly
>
_. (2) Mechanism fixing angle
assembly (Rear surface) B-4
Note) The numbers following
A and B indicate the
I
/Ai! I
I
screw tightening order
n chassis
assembly
Item
TgMening torque Quantity
A @ S Tight Ml.4 x L3 70mN.m 3
B @ S Tight Ml.4 x L2 70mN.m
6
AHC control lever
2) Lock lever guid
Positioning h;e
Item
ImgMeNng torque 1 Quantity
9 S Tight. Ml.4 x L2 1 70mN.m 1
1
(5) Capstan
motor@
(2) Shifterdrive
lever assembly
,,‘m q
MeXnism fixing anale
ID 19Specl
, 1
ial screw
40mN.m
1 4
Ml .4 x L1.6
@@@
(4) Intermediate gear angle
sub assembly
(1) Intermediate pulley
(2) Center pulley asse
Item
ITtthteNng toqus 1 Quantity
B 1’9 S Tight. Ml.4 x L2 I 70mN.m I
1
eck
Guide rail sub assembly
(Rear surface)
Item
TghteNrg torque Quantity
E Q Special screw
40mN.m 2
M1.4xL1.5
To Next Page
Loading...
