VL-SD20U
2) Shifting to the normal operation mode
Set the data for the address “0000” to ” FF”.
0
This shifts the mode to the normal operation mode.
0
Press the “CONTINUE” key, and the “CAM ADJ” display goes out of the screen, enabling the normal operation.
(5) Camera unit adjustment procedure
( 1. Auto focus adjustment
I
1
2. Iris basic adjustment
1 3. Black balance adjustment/A/f noise adjustment
I
( 4. iris AE adjustment
I
5 White balance coarse adjustment
6. Color gain coarse adjustment
7. White balance adjustment
8. Color gain adjustment
1 9. Auto white balance adjustment
* The above 1. Auto-focus function adjustment and 2. Iris basic adjustment are performed in the auto-focus function adjustment
mode, whereas the other adjustments are made in the camera signal system adjustment mode.
* After completing the auto-focus adjustment mode, set the camera signal system adjustment mode. (Take care that the adjustment
mode transfer address is different.)
10-14
To Next Page
Loading...
