XE-A11OVS
CHAPTER 6. SERVICE PRECAUTION
1. Printer
Since the service parts of the printer for this model are of low price,
only the printer unit is supplied. Therefore, the printer component
pans are not supplied and no service document on them is issued.
For troubleshooting of the printer, refer to the tabie beiow:
* Printer iife: 300 thousand lines (XE-A11O:M-31)
700 thousand iines (XE-A130: M-42V)
ink roil life: 1 miiiion characters
Phenomena
Check point/possibie cause
1
1
Repair
t
● The printer motor is iocked and the
● Check if the printer cabie is disconnected.
z
● Check and repair the printer cabie.
buzzer sounds intermittentiy.
● The printer does not work properly.
c Check if the printer life is reached.
~. Repiace the printer.
● Check if any foreign materiai is attached to the
● Remove the foreign materiai. (After removing the
printing type wheei or the gear section.
foreign material, set the mode switch to “REG”
and press “CL” key.)
● Defective print (Lack on the upper/
● Check if the printing type is worn down.
● Repiace the printer.
iower or ieff/right side)
● Check if any foreign material is attached to the
‘
● Remove the foreign materiai. (After removing the
printing type wheei.
foreign material, set the mode switch to “REG”
and press “CL” key.)
I
● Thin print ● Check if the ink roll iife is reached. ~● Replace the ink roli.
● Check if the ink roii is properiy attached.
● Attach the ink roli properiy.
● Check if the printing type wheel is worn down
● Repiace the printer.
because of life.
@ Uneven pitch of print paper feed
● Check if the roii paper size is proper.
,
● Use the roll paper of foiiowing sizes:
Paper width: 57.5 *0.5 mm
\ Outside diameter:
980 mm or iess
inside diameter of paper tube: 912 mm or iess
Paper thickness: 0.06-0.085 mm
● Check if a ioad is appiied to the roii paper ● Remove the cause to remove the ioad.
during paper feed because of a foreign
material attached to the roil paper.
-11-
To Next Page
Loading...
