Sharp XE-A137 - Basic Function Programming; Abbreviations and Terminology; Prior to Programming

10
BASIC FUNCTION PROGRAMMING
Before starting sales entries, you must first program necessary items so the cash register suits your sales
needs. In this manual, there are three sections, BASIC FUNCTION PROGRAMMING (pages 10-20) where
required items must be programmed, “AUXILIARY FUNCTION PROGRAMMING” for using all available
keyboard keys and “ADVANCED FUNCTION PROGRAMMING”. Further details can be freely downloaded from
the URL.
1 Abbreviations and Terminology
Dept.: Department; a category for merchandise classifications. Every sales item should belong to a
department.
PLU: Price Look Up; a category for merchandise classifications. PLUs are used to call up preset prices by a
code entry.
VAT: Value Added Tax
X report: Report to read sales data
Z report: Report to read and reset sales data
Receipt ON/OFF function: To print or not to print receipts in the REG mode.
2 Prior to Programming
■
Procedure for programming
1. Check to see whether a paper roll is present in the machine. If there is not enough paper on a roll, replace it
with a new one (refer to “Replacing the Paper Roll” in “OPERATOR MAINTENANCE” chapter for the
replacement).
2. Put the mode key in the mode switch and turn it to the Z/PGM position.
3. Program necessary items into the cash register.
Every time you program an item, the cash register will print the setting. Please refer to print samples in each
section.
4. If necessary, issue programming reports for your reference.
NOTE
• On the key operation example shown in the programming details, numbers such as “221012” indicates
the parameter which must be entered using the corresponding numeric keys.
• Asterisks in the tables shown in the programming details indicate default settings.
■
Description of special keys
0
,
1
to
9
Used for numerical number entry.
:
Used for character code entry.
l
Used for cancel entry.
s
Used for data decision entry.
A
Used for programming termination entry.