Sharp XE-A213 - Page 2

Install the Paper Roll
Receipt
• Lift up the print roller release lever to unlock and open
the print roller arm.
• Set a paper roll in the paper roll cradle as per the diagram.
• Feed the end of the paper along with the paper
positioning guides as per the diagram.
• While holding down the paper, slowly close the print roller
arm, and push down the arm until you hear a click locking
the arm. Make sure you securely push down the center of
the wing part of the arm as per the diagram. The paper will
be fed automatically.
• Cut off the excess paper using the edge of the inner cover,
and replace the printer cover. Press the key to make
sure the paper end comes out of the printer cover and
clean paper appears.
NOTE: If the print roller arm is not securely locked,
the printer will not work correctly. If this problem
occurs, open the arm, and close the arm as
instructed above.
Journal
• Insert the end of the paper into the slit of the spool. (Press the
key to feed more paper if required).
• Wind the paper two or three turns around the spool shaft.
• Set the spool on the bearing and press the key to take up
excess slack in the paper.
• Replace the printer cover.
3
3.
4.
1.
2.
5.
PGM
MGROPX/Z
REG
X2/Z2
X1/Z1
Mode Lock
Setting The Date And Time
Set the mode switch to the PGM position.
Setting the Date
Enter the date in 8 digits using the day month-year (DD-MM-YYYY) format.
Then press .
Example: Date (26 August, 2003)
Setting the Time
Enter the time in 4 digits ("hhmm" format) using the 24 hour system. Then press .
Example: Time (2:30pm) .
4
#
#
#
#
26 0 82003
1420
PGM
MGROPX/Z
REG
X2/Z2
X1/Z1
Mode Lock
Turning off the Receipt Printer
The printer can be turned off to save paper.
• Insert the manager (MA) key into the mode lock and turn to the OPX/Z position.
• Press the key.
• Turn the key back to REG mode. The receipt is now turned off.
• To turn the receipt ON again, turn the key to OPX/Z and press the key again.
• Turn the key back to the REG mode.
5