Sharp XG-PH50X - Connecting to Video Equipment; Connecting to Video Equipment that Has an HDMI Output Terminal with a DVI to HDMI Cable

-30
Connecting to Video Equipment
Before connecting, ensure the power cord of the projector from the AC outlet is unplugged,
and that the devices to be connected are turned off. After making all connections, turn on the
projector and then the other devices.
The projector has a DVD digital terminal, computer-RGB/component terminal, S-video termi-
nal and video terminal for video input. Refer to the listed illustrations on how to connect audio-
visual equipment.
If your audio-visual equipment has an RGB output terminal or component output terminal,
use the computer-RGB/component terminals (INPUT 1 or 2) on the projector for video con-
nection.
Connecting to Video Equipment That Has an HDMI Out-
put Terminal with a DVI to HDMI Cable
Use a DVI to HDMI cable when connecting HDMI video equipment such as DVD players to the
INPUT 3 terminal.
Note
• Select the input signal type of the video equipment. See page 63.
• While the projector is connected to video equipment that has an HDMI output terminal, only the video
signal can be input to the projector. (Connect the AUDIO input (2, 3) terminal for audio input.)
ø3.5 mm stereo minijack to RCA audio cable
(commercially available)
To HDMI output terminal
To AUDIO input
(2, 3) terminal
DVI to HDMI cable
(commercially available)
To audio output
terminals
Video Equipment
Side view
To INPUT 3 terminal