80
When installed with the
AN-TK202
1
Attach the ceiling mount to the
ceiling.
First screw a bolt into the hole (smallest
hole) and tighten it enough to keep the
mount in place. Then, do the same for the
holes
, and .
Position the four corners correctly, and
then tighten all bolts fi rmly.
Use M8-type bolts. (Bolt type may vary
depending on the method of installation.)
Use the washers supplied with the ceiling
mount.
Caution
Ask your dealer or service shop to install the
ceiling mount. Sharp will assume no
responsibility whatsoever if inadequate
installation causes your projector or attached
devices to fall out of place.
•
•
•
•
To Next Page
Loading...
