Sharp XL-45H - Radio Recording and Tape Erasure

02/10/1 XL_45H_H_E4.fm
E-24
ENGLISH
XL-45H
8
7
6
5
4
3
2
1
Tape Recording
To interrupt recording:
Main unit operation:
Press the button.
To resume recording, press the button.
Remote control operation:
Press the button.
To resume recording, press the button.
To st op recording:
Press the button.
The tape will stop. When the button is pressed again, the CD will
stop.

Recording from the radio
To st op recording:
Press the button.
Notes:
z
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
z
Whilst recording from the radio, the recording pause function
does not work.

Erasing a recorded tape
1
Tune in to the desired station (see page 14).
2
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the ( ) button.
1. Load the tape to be erased into the cassette compartment with
the side to be erased facing toward you.
2. Press the FUNCTION button until "TAPE" appears on the dis-
play.
When operating with the remote control, press the TAPE button.
3. Press the button.
4. Press the ( ) button to start erasing.
Erase-prevention tabs of cassette tapes:
z
When recording on a cassette
tape, make sure that the erase-
prevention tabs are not re-
moved. Cassettes have remov-
able tabs that prevent
accidental recording or erasing.
z
To protect the recorded sound,
remove the tab after recording.
Cover the tab hole with the ad-
hesive tape to record on the
tape without the tab.
Side A
Tab for side B Tab for side A