Sharp XL-45H - Tape Recording; Recording from CD to Tape

02/10/1 XL_45H_H_E4.fm
E-23
ENGLISH
XL-45H
Tape Recording
Recording to a cassette tape
Before recording:
z
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
z
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
z
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
z
For recording, use only normal tapes. Do not use metal or
CrO tapes.

Recording from a CD
To perform programmed recording:
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "CD STOP" appears on
the display.
When operating with the remote control, press the CD button.
3
Load the desired disc.
4
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
5
Press the button.
Recording will be paused.
6
Press the ( ) button.
z
CD playback will start in a few seconds after the tape starts.
z
When the playback of the disc is finished, the CD and the
cassette will stop automatically.
1 Programme tracks (see page 13).
2 Press the button.
3 Press the ( ) button.