02/8/6 XL-HP500W(A)3.fm
E-23
ENGLISH
XL-HP500W
Tape Recording
Recording to a cassette tape
Before recording:
!
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
!
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
!
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
!
For recording, use only normal tapes. Do not use metal or CrO
tapes.
" Recording from a CD (CDs)
You can record the desired CD using the DISC SELECT - ( 1
- 3) buttons.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button and load the desired disc.
3
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
4
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
5
Press the button.
Recording will be paused.
6
Press one of the DISC SELECT - ( 1 - 3) buttons to
start recording.
!
To record on both sides, begin on side A. (If recording is
started from side B, the tape will not switch over to side A.)
!
Recording is started from the selected CD. When the play-
back of the last track is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
!
CD playback will start approximately 7 seconds after the
tape starts.
To Next Page
Loading...
