Page 22 SHARP SL-C1000/3x00
///TRIsoft OHG SL-C1000/3x00 Quickstart
Localisation after factory-reset
With a special reset procedure it is possible to bring the Zaurus back to factory state. If
you played too much with sensitive configuration files this is your best chance to get a
working Zaurus back.
Factory state means that the device will talk only japanese with you. With a backup on a
memory card the last working state is restored easily.
The data would be lost, if there were no backup. A "Localisation-Backup" can be
downloaded from our website http://www.trisoft.de and copied onto a memory card.
A recent backup must simply be read back via "Restore". The difficulty lies in the
recognition of the correct icons to click, but don’t worry : Here comes the easy
step-by-step guide with pictures for your short journey through the japanese world of
Zaurus.
Attention :
The backup needs to be placed in a subdirectory called “Backup_Files” !
The Zaurus checks only this directory for backup sets.
Reset (Flashmenu)
To access the flash menu, the following steps are necessary:
• Turn off the Zaurus, pull out the USB cable or other power supplies.
• Unlock the battery compartment and take out the battery.
• Wait for approx. 5 seconds.
• Tick the reset button (see page 11)
• Reinsert the battery, close the cover and turn the switch back to "Betrieb".
• Connect the power supply and wait until the yellow charging LED lights up
(without AC connected, the Zaurus won’t start the Reset procedure !).
To Next Page
Loading...
Need help?
General
