Unboxing and Assembly
9
Shell
RIDE
It is recommended that the bike be inspected and adjusted by a certified bicycle mechanic
before riding.
You Will Need:
4mm, 5mm and 6mm Allen wrench
13mm and 15mm open wrench
1- Carefully remove the bike from the box.
A. Use caution when opening the box as there may be staples exposed when opening the lid.
B. It is easier to clip the zip ties attaching the front wheel to the bike and remove the front wheel
from the box first.
C. Take out all the accessories and the box with pedals and other miscellaneous parts, and the
Battery Charger before removing the bike.
2- Remove all bubble wrap and other packaging materials and place them back into the box.
3- Tighten the seat-post into the seat-tube and hang the bike from a bike repair stand (if possible).
A. If you do not have a repair stand, place the bike on
the floor and engage the kickstand. Use caution as the
bike could tip over prior to install the front wheel, even
with the kickstand engaged.
To Next Page
Loading...
General