Shelly Wave i4 - 9 Z-Wave Parameters; Parameter No. 1 - SW (SW1) Switch Type; Parameter No. 2 - SW2 Switch Type

14
When the menu is executing the LED will be blinking red in Mode 3.
Alarm Mode
NA
9. Z-Wave® Parameters
Parameter No. 1 - SW (SW1) Switch type
This parameter defines how the Device should treat the switch (which type) connected to the
SW (SW1) terminal.
Value size: 1 Byte
Default value: 0
Values & descriptions:
• 0 - momentary switch (push button),
• 1 - toggle switch (contact closed - ON / contact opened - OFF),
• 2 - toggle switch (Device changes status when switch changes status)
Parameter No. 2 - SW2 Switch type
This parameter defines how the Device should treat the switch (which type) connected to the
SW2 terminal.
Value size: 1 Byte
Default value: 0
Values & descriptions:
• 0 - momentary switch (push button),