TOP VIEW OF ANCHORING WING KIT
Wing
Wing
While lifting one wing out and up at the middle
insert an extension pole into the tab at the middle
of the wing. Make a knot in the end of one of the
ropes and place it over the tab and pole end as
shown in Figures C & D. Place the anchor
securely in the ground about 3' from the
extension pole. (Fig. E)
Slide the rope clamp up the rope to tighten the wing.
Proceed to each of the two corners of the wing and
secure the anchors approximately 3' diagonally
from the corner. (see anchoring top view)
Repeat for the opposite side wing.
Fig. C
Fig. E
3'
3'
3'
Caution, Care & Cleaning
Bungee cords are under extreme tension. Please use caution when applying as they may snap out of your hand and
cause injury. Safety goggles must be worm when securing bungees.
During the first few months of use, it will be necesssary to tighten the cover a few time. Be sure that the cover is kept
tight. Loose fabric will deteriorate quickly. Do NOT apply any “protect & shine” type products to the cover and ends or use
any harsh abrasive cleaners. The cover may be cleaned with mild soap and water.
To Previous Page
Loading...
Need help?
General
