Shenchen Pump LabV Series
4.8 Communication Setting Interface
Click System Settings button in the main interface, then click Communication
button to enter Communication Settings interface.
This pump support Modbus--RTU Mode. Please select baud rates and
communication interface (RS485/RS232). Click Slave No. button to enter peristaltic
pump address No.(range:1-32 ), select communication enable is ON. Then this
pump can be communication with master, receiving master signal.
Note: After settings, the peristaltic pump only receives communication control when
in the main interface, it is invalid for the communication control in the other settings
interface.
To Next Page
Loading...