Shenchen Pump LabV Series
A. Speed/Flow Rate Display: In the flow rate mode, displays the current flow
rate, the motor speed is displayed at the C frame. In the speed mode, displays
the current set up speed, flow rate is displayed at the C frame. Click A to
amend the flow rate or speed. When dispensing function turn on, A is
forbidden, not allowed to amend the flow rate or speed.
B. Real-time Dynamic Display: Real-time display of the current running status,
dynamic display of the running results.
C. Real-time Parameter Display: Display the current running state and setting
up parameter. When the fixed volume measurement turns on, displays the
fixed volume measurement parameter; when the dispensing function turn on,
display the dispensing parameter. When these two functions turn off,
displaying parameter is all zero.
D. Setting Parameter Display: Display the fixed volume measurement,
dispensing state information, the model of pump head and tube size.
E. Date and Time Display: Display the current date and time, you can change it
in the system settings. When it displays an alarm clock on the right side, it
means the timer start and stop function had turned on.
F. System Settings Button: Click this button, set up other parameters.
G. Flow Calibration Button: Click this button to enter the flow rate calibration
interface.
H. Date & Time Button: Click this button to enter set up current date and time
interface.
I. Fixed Volume Measurement Button: Click this button, enter the fixed
volume measurement interface.
J. Dispensing Button: Click this button, enter dispensing interface.
K. Timer Start and Stop Button: Click this button, enter timer start and stop
interface.
To Next Page
Loading...