To Next PageTo Next PageHow to fix a Sherwood Newcastle R-865 with no power?
If your Sherwood Receiver has no power, first ensure the AC input cord is securely connected. If it is, check the AC wall outlet by testing it with a lamp or another appliance to make sure the outlet is functioning correctly.
What to do if my Sherwood Newcastle R-865 Receiver has no sound?
If you're experiencing no sound from your Sherwood Receiver, there are several things to check: * Make sure the speaker wires are properly connected. * Adjust the master volume to an audible level. * Ensure the MUTE button is not activated. * Verify that the selected decoding mode matches the input signal format. * Confirm the correct input source is selected. * Check all connections between the components to ensure they are correctly made.
Why isn't my Sherwood Newcastle R-865 remote control working?
If your Sherwood Receiver remote control isn't working, first replace the batteries. If that doesn't solve the issue, check for any obstructions between the remote and the receiver's sensor and remove them.
How to troubleshoot no sound from Sherwood Receiver surround speakers?
If you are not getting any sound from the surround speakers on your Sherwood Receiver, make sure that a surround mode is selected instead of normal stereo mode. Also, check that the master volume and surround level are appropriately adjusted. Ensure that you are using a stereo or surround source, not a monaural one, and verify that the surround speaker setting is not set to 'None'.
How to fix Sherwood Newcastle R-865 Receiver when stations cannot be received?
If your Sherwood Receiver is not receiving stations, connect an antenna to the receiver. Ensure that you tune in the desired station frequency and try moving the antenna to a different position to improve reception.
Why is there no sound from the center speaker on my Sherwood Receiver?
If there's no sound coming from the center speaker of your Sherwood Receiver, ensure that you've selected the correct surround mode and not Dolby Virtual Speaker or normal stereo mode. Check that the center speaker setting is not set to 'None'. Also, adjust the master volume and center level to ensure they are not too low.
What causes hissing noise during AM reception on a Sherwood Newcastle R-865?
If you experience continuous or intermittent hissing noise during AM reception with your Sherwood Receiver, especially at night, the noise could be caused by motors, fluorescent lamps, or lightning. Try to keep the receiver away from these noise sources. You might also consider installing an outdoor AM antenna.
Why is my Sherwood Receiver FM reception so poor?
If you're getting poor FM reception on your Sherwood Receiver, make sure an antenna is connected. If an antenna is already connected, try changing its position to improve the reception.
How do I fix no sound from Sherwood Receiver surround back speakers?
If you're not getting any sound from the surround back speakers on your Sherwood Receiver, ensure that the input signal format or the current surround mode supports 7.1 (or 6.1) surround. Also, verify that the power amplifier for the surround back channels is correctly assigned and that the master volume and surround back level are appropriately adjusted. Make sure the surround back speaker setting is not set to 'None'.
How to stop continuous hissing noise during FM reception on my Sherwood Newcastle R-865 Receiver?
If your Sherwood Receiver exhibits continuous hissing noise during FM reception, especially when receiving a stereo broadcast, it may be due to weak signals. Try changing the position of the antenna or installing an outdoor FM antenna to improve signal strength.
General| Signal to noise ratio | 100 dB |
|---|---|
| Headphone Output | Yes |
| Frequency Response | 10 - 100000 Hz |
| Tuning range | AM/FM |
| Input sensitivity | 200 mV |
| Speaker load impedance | 8 ohms |
