To Next PageTo Next PageWhat to do if other Sherwood components do not react to remote control commands?
If other Sherwood components aren't responding to remote control commands, ensure the DIGI LINK connections are properly made.
What to do if a video label cannot be displayed on Sherwood Newcastle R-956 Receiver?
If a video label cannot be displayed on your Sherwood Receiver, it may be due to a malfunction caused by external influences like static electricity. You can clear it using the “To clear a video label” function. (Refer to “Correcting or clearing a video label” on page 30)
Guide to unpacking the audio/video receiver and initial setup.
Important safety and operating guidelines to read before use.
Instructions for connecting FM and AM antennas.
Guide for connecting turntables, CD players, and tape decks.
Explains the information shown on the receiver's front display.
Details about the front panel video input jacks.
Explains the basic functions of the Sherwood and OSD modes for the remote.
Step-by-step guide to selecting input sources and listening to audio.
How to configure speaker settings for different channels and subwoofer.
Guide to adjusting the volume level for individual speaker channels.
Steps for automatically tuning in radio stations by band and frequency.
Process for manually tuning radio stations using the control knob.
Information on what settings are memorized and how they are backed up.
Steps for recording audio using the TAPE MONITOR function.
Process for dubbing video signals from one source to VIDEO 1.
How to check current operational settings like input, surround, and tone.
Explains dynamic range compression for Dolby Digital sound tracks.
Guide to setting the automatic shut-off timer for the receiver.
How to adjust the brightness of the receiver's display panels.
How the receiver shows current operational status on the monitor TV.
Guide to navigating setup menus for various receiver functions.
General