LUBRICATION AND MAINTENANCE
54
Tractor that have been placed in storage should be
completely serviced in the following manner before
using :
1. Inflate the tires to the recommended pressures,
and remove the blocking.
2. Check the oil level in the engine crankcase, the
common sump (for the hydraulic lift, transmis-
sion, rear axle and optional power steering), and
optional front wheel drive axle.
3. Install a fully-charged battery and remove the
exhaust cover, if other than a rain cap.
4. Check the cooling system for proper level of
50/50 solution of antifreeze and clear water.
5. Remove pedal spacer from between clutch
pedal and step plate.
6. Start the engine and allow it to idle a few min-
utes. Be sure the engine is receiving lubrication
and that each control is functioning correctly.
7. Drive the tractor without a load and check to be
sure it is operating satisfactorily.
To Next Page
Loading...
