Before Using the System
iii
Safety Instructions
Autograph systems generate very large forces used to measure the strength characteristics of
materials or products.
In some situations it could cause material damage or serious harm to humans (such as injury or
death).
Therefore, to ensure the system is used safely, please thoroughly understand and observe the
following warnings.
Operating the system carelessly could result in serious injury or death. Keep
hands, head and all other body parts away from the testing space when the
crosshead is in motion.
Moving parts can produce dangerous forces corresponding to the system
capacity. All operators should read the instruction manual thoroughly to ensure
they operate the system correctly. Control access to the system to ensure only
trained operators operate the system.
Do NOT open the shaft cover. Do NOT leave the shaft cover open while
performing tests. To lubricate the ball screws, open the rubber cap on the side
of the column cover and connect the grease gun to the grease nipple on the
ball nut.
In the case of using the testing machine without protection cover, keep the
face and body away from the test specimen during tests. When the specimen
breaks, flying debris could injure eyes or other body parts. Always use a safety
guard or other measure to provide protection from broken specimens.
To Next Page
Loading...
Need help?
General
