What does 'CAL E2' mean on my Shimadzu Scales?
If your Shimadzu Scales displays 'CAL E2', it means something was on the pan during span calibration. Remove the item and wait for the span calibration to restart.
How to troubleshoot a Shimadzu Scales with a blank display?
If nothing appears on the display of your Shimadzu Scales, first ensure that the AC adapter is properly connected. If it is, check that the power supply is turned on.
Why does the display on my Shimadzu Scales fluctuate?
If your Shimadzu Scales display is fluctuating, here are a few things to consider: * The balance might be experiencing vibration or drafts. Try relocating it. * If weighing a volatile sample, use a lid. * If the sample is charged, place it in a metallic container. * Ensure the sample's temperature matches the weighing chamber's. * Separate the balance from any electrical noise or electromagnetic waves. * If air currents are present, keep the weighing chamber door slightly open when not in use.
What to do if my Shimadzu Scales displays 'Err 20'?
If the Shimadzu Scales displays 'Err 20', it indicates that an incorrect value has been entered. Review the numeric value you entered and correct it.
What does 'Err24' mean on my Shimadzu Scales and how do I fix it?
If your Shimadzu Scales displays 'Err24', this indicates low battery pack voltage. You should charge the battery pack.
Critical safety warnings indicating potential severe injury or death if not heeded.
Safety cautions for potential minor injury or equipment damage.
Specifies the required power supply voltage and adapter for the balance.
Guidelines for selecting an optimal and safe location for balance installation.
Step-by-step instructions for setting up the electronic balance.
Procedure for allowing the balance to stabilize before use.
Important notes and guidelines to observe for safe and correct operation.
Configuring the balance to the appropriate measurement mode.
Detailed steps for performing a weighing measurement.
Procedure to choose the type of span calibration to be performed.
Procedure to set the default calibration type for the balance.
Steps to perform the standard span calibration.
Step-by-step guide for calibrating the balance using its internal weight.
Configuration for automatic span calibration based on internal clock times.
Procedure to set the specific times for automatic span calibration.
Procedure for testing the consistency of measurements by repeated weighing.
Procedure to test the balance's accuracy when loads are off-center.
Guidance for diagnosing and resolving common operational issues.
List of error messages with descriptions and corrective actions.
Technical details and performance characteristics of the balance models.
Specific troubleshooting steps for issues with the WindowsDirect communication feature.
Reference list of commands for controlling the balance via peripheral devices.
Detailed steps for performing span calibration on the balance.
To Next Page
General
