36
Installation/removal
Installing the battery mount
` BM-E8020
If the following cables will be internally routed through the frame, route them through the
frame before installing BM-E8020:
• Electric wire
• Brake hose, brake cable, and shift cable
When installing BM-E8020 inside the frame, be careful that the cables listed above are not
pinched.
The SHIMANO original tool TL-BME03 can be used to easily determine the installation location
for the key unit.
1. Install the lower case to the frame.
(1) Ensure any cables run internally through the down tube pass through the mount
installation area.
(2) Install the lower case on the lower side of the down tube.
10 N·m
Lower case mounting screw(2)
Lower case
Down tube
Mount installation area
Internally routed cable
(1)
(shift wire, electric wire, and brake wire/brake hose)
Front
To Next Page
Loading...
