Shimano Steps EW-CP100 - Battery LED Lamp Error Indication; When There Are Five Battery LED Lamps

34
Installation/removal
Installing the battery mount
(3) Secure the key unit cover.
0.6 N·m
(Temporary)
Key unit cover mounting screw
(1)
(3)
(2)
Key unit cover
Battery
5. Install the upper case.
(1) Pass the power cord from the upper case through the hole in the lower case.
(2) Set the upper case to the lower case.
* Make sure that the bellows on the base of the power cord is exposed from below the
lower case.
(3) Secure the upper case.