Shimano BL-T6000 - Final Bleeding Steps for BR-M6000; Securing Bleed Boss and Checking Lever (BR-M6000)

27
To be continued on next page
MAINTENANCE
Adding Shimano genuine mineral oil and bleeding air
9
(B)
(A)
Once no more air bubbles come from the
bleed boss, temporarily close the bleed
screw.
(A) Bleed screw
(B) Bleed boss
10
With the brake lever depressed, open
and close the bleed screw in rapid
succession (for approximately 0.5 seconds
each time) to release any air bubbles
which may be in the brake calipers.
Repeat this procedure about 2 to 3
times.
Then tighten the bleed screw again.
Tightening torque
4 - 7 N·m