Shindaiwa T235 User Manual (English)

Other manuals for Shindaiwa T235

Operator's Manual52 pages

Owner's/Operator's Manual28 pages

Questions and Answers:

D
denise22Aug 12, 2025
What to do if my Shindaiwa T235 Trimmer engine does not start?
- P
  Patricia ShermanAug 13, 2025
  If your Shindaiwa Trimmer engine doesn't start, there could be several reasons. First, ensure the fuel is fresh, clean, and of the correct mixture (unleaded gasoline with a pump octane of 89 or higher mixed with an air cooled engine oil that meets or exceeds ISO-L-EGD and/or JASO FD classifi ed oils at 50:1 gasoline/oil ratio). Also, make sure the ignition switch is in the “I” (ON) position. Check the spark plug; if it's fouled or improperly gapped, clean and gap it according to the specifications. If the plug is damaged or the wrong size, replace it, consulting the Specifications section for the correct type and gap. If the priming pump is not functioning properly or the ignition ground is shorted, consult an authorized Shindaiwa servicing dealer.
M
Margaret PhelpsAug 16, 2025
Why is my Shindaiwa T235 Trimmer engine hard to start?
- W
  Wanda ThomasAug 16, 2025
  If your Shindaiwa Trimmer engine is hard to start or doesn't start at all, several factors could be the cause. It might be due to a fuel strainer or fuel line obstruction, in which case you should clean or replace them, or a fuel mixture that's too rich, so you should open the choke, clean or replace the air filter, and adjust the carburetor. Also, make sure the stop switch is turned ON. A faulty spark plug could also be the culprit; adjust the gap to 0.65mm (0.026 in.) or clean/replace the plug. For carburetor issues, electrical problems or interlock switch, it's best to consult your dealer.
S
Stanley DawsonAug 20, 2025
Why Shindaiwa T235 has low power output?
- M
  Michelle NealAug 20, 2025
  If your Shindaiwa Trimmer has low power output, try using a lower throttle setting. Refill it with fresh, clean unleaded gasoline with a pump octane of 89 or higher mixed with an air cooled engine oil that meets or exceeds ISO-L-EGD and/or JASO FD classifi ed oils at 50:1 gasoline/oil ratio. Service the air cleaner element. Tighten or replace the spark plug, checking the Specifications section for the correct plug and gap. Repair or replace the fuel filter and/or fuel line. If these steps don't resolve the issue, consult with an authorized Shindaiwa servicing dealer.
H
Henry CarlsonAug 25, 2025
What to do if Shindaiwa T235 Trimmer engine runs, but dies?
- K
  Kristen DicksonAug 25, 2025
  If your Shindaiwa Trimmer engine runs but dies or doesn't accelerate properly, the air filter might be dirty, so you should clean or replace it. Another possible cause is a dirty fuel filter, so you should replace the filter or the fuel. Also, the fuel vent might be plugged, so you should clean or replace it.
D
Dr. Andrea SmithAug 27, 2025
How to fix Shindaiwa T235 engine that does not accelerate properly?
- M
  michelle07Aug 28, 2025
  If your Shindaiwa Trimmer engine runs, but dies or does not accelerate properly, the spark plug might be dirty or worn, so you should clean and adjust or replace it. Improper adjustment may also be the cause, so you should adjust it. Check if the cooling system is dirty or plugged and clean it. Finally, a plugged spark arrestor screen may be the problem, so you should replace it.
R
Ryan KingAug 31, 2025
What to do if Shindaiwa T235 Trimmer engine difficult to shut off?
- C
  Crystal OlsonAug 31, 2025
  If your Shindaiwa Trimmer engine is difficult to shut off, the ground (stop) wire might be disconnected, or the switch could be defective; test and replace them as required. Overheating due to an incorrect spark plug can also cause this issue, so replace the spark plug, checking the Specifications section for the correct plug and gap. Let the engine idle until it cools down. Adjust the idle; check the Specifications page for the correct idle speed.
M
Megan MaynardSep 4, 2025
What to do if cutting attachment moves at engine idle on Shindaiwa T235 Trimmer?
- J
  Joanna GonzalezSep 4, 2025
  If the cutting attachment moves at engine idle on your Shindaiwa Trimmer, the gearcase might be loose. Tighten the gearcase securely. Alternatively, the main shaft could be bent, or the bushings worn or damaged; inspect and replace these as necessary.
A
adam72Sep 7, 2025
Why is there excessive vibration in my Shindaiwa T235?
- J
  Jeffrey SmithSep 8, 2025
  Excessive vibration in your Shindaiwa Trimmer may be due to the shaft not being properly installed in the powerhead or gearcase. Inspect and reinstall it as required. If the problem persists, consult with an authorized Shindaiwa servicing dealer.

Shindaiwa T235 Specifications

General

Engine Displacement	21.2 cc
Fuel Type	Gasoline
Starting System	Recoil
Engine Type	2-Stroke
Shaft Type	Straight
Cutting Swath	17 inches
Dry Weight	4.5 kg
Weight	4.5 kg