Shinkawa VM-5T User Manual

11. SITE INSPECTION VM-5S
-83-
11-4 CHECKS PRIOR TO OPERATION
Result
Check Item Description
Item CH-1 CH-2
While stop
1. Interconnections
2. Insulation of connectors
3.
Terminations of shielded cables
4. Sensor set gap value
5. Sensor set gap voltage
6. Trigger level value
7. Hysteresis
8. SPEED RELAY set value
9. Monitor unit check
Refer to
4. INTERCONNECTION on
page 4.
Approx.
mm
Approx.-
V
Preset to Auto Trigger
V
rpm
Input dummy signal from
oscillator and verify operation.
Result
Result
Result
Set value
Voltage
Set value
Set value
Set value
Result
□ □
□ □
□ □
mm mm
V V
□ □
□ □
SR2 SR4
SR1 SR3
□ □
While turning
1. Monitor output waveform
2. Pulse output waveform
3. Trigger level and hysteresis
set values
(if necessary as per results of
items 1 and 2)
4. Turning motor
Operation check by switching
turning motor ON/OFF
Refer to
7. PARAMETER SETTING
on page 26.
Verify OFF/ON operation of
SPEED RELAY contact
output.
(A)
(B)
(C)
(D)
Trigger
level
Hysteresis
Result
V V
V V
V V
V V
V V
V V
□ □
Verification of initial operation Set the speed relay contact
output circuit to “Disable”,
check the sensor and
trigger pulse waveform and
trigger level are
appropriate.
Result
□ □
While operating
Operation check under normal
operating conditions
Result
□ □
A
←B
←C
D

Shinkawa VM-5T Specifications

General

Brand	Shinkawa
Model	VM-5T
Category	Monitor
Language	English