ShoreStation Hydraulic Wireless Pairing Instructions
Pair the wireless controllers with the lift controller.
o Unlock the key fobs.
o Turn the lockout key to the ON position.
o Trip the top limit switch 10 times in less than 30 seconds. The light 1 output should
flash once to indicate it is in pairing mode. This process is the same for when no upper
limit switch is installed and the jumper wire is installed. Pull the plug apart, slide one
side in until a connection is made then tap other connection 10 times.
o Press the UP or DOWN button on the wireless control once. The Light 1 output
should flash once to indicate it paired with the wireless control. Repeat for the other
controller.
o The Light 1 output should flash 2 times after a few seconds to indicate it is no longer
in pairing mode.
o Test the wireless controllers to see if they run the lift. If not, the wireless controls may
need to be replaced.
To Next Page
