Shure PGX - Troubleshooting

5
Troubleshooting
Issue Indicator Status Solution
No sound or faint
sound
Transmitter power light on,
receiverLEDson
• Performautomatictransmittersetup
• Verifyallsoundsystemconnections
ReceiverLEDoff • Make sure AC adapter is securly plugged into
electrical outlet
• Make sure AC electrical outlet works and is
supplying proper voltage
Transmitter power light
glowingorflashingred
• Replace transmitter batteries
• Ifindicatorcontinuesflashingredafter
batteries are replaced, the transmitter
and receiver may belong to incompatible
frequencybands.ContactyourShurereseller
forassistance.
Transmitterpowerlightoff • Turn on transmitter
• Make sure the +/- indicators on batteries
match the transmitter terminals
• Insertfreshbatteries
Distortion or
unwanted noise
bursts
N/A • RemovenearbysourcesofRFinterferance
(CDplayers,computers,digitaleffects,in-ear
monitor systems, etc.)
• ‣Changereceiverandtransmittertoa
differentfrequency
• ‣Reducetransmittergain
• ‣Replacetransmitterbatteries
• ‣Ifusingmultiplesystems,changethe
frequencyofoneoftheactivesystems
Distortion
increases
gradually
Transmitter power light
glowingorflashingred
Replace transmitter batteries
Sound level
different from
cabled guitar
or microphone
or when using
different guitars
Adjusttransmittergainasnecessary
Cannot turn
transmitter on
Transmitterlightflashingred Replace transmitter batteries