Shure PGX - Specifications

6
SPECIFICATIONS
PGX1 Bodypack Transmitter
Audio Input Level
–10dBVmaximum,gainposition=mic
+10dBVmaximum,gainposition=0dB
+20dBVmaximum,gainposition=–10dB
Gain Adjustment Range
30dB
Input Impedance
1MΩ
RF Output Power
10–30mW
varies by region
Pin Assignments
TA4M:
1:ground(cableshield)
2:+5VBias
3:audio
4:Tiedthroughactiveloadtoground(Oninstrument
adaptercable,pin4floats)
Dimensions
108mmx64mmx19mm(HxWxD)
Weight
81g(3oz.),withoutbatteries
Housing
Molded polycarbonate case
Power Requirements
2 “AA” size alkaline or rechargeable batteries
Battery Life
upto8hours(alkaline)
PGX2 Handheld Transmitter
Audio Input Level
+2dBVmaximum,at–10dBgainsetting
–8dBVmaximum,at0dBgainsetting
Gain Adjustment Range
10dB
RF Output Power
10–30mW
varies by region
Dimensions
254mmX51mmdia.(10X2in.)
Weight
81g(10.2oz.),withoutbatteries
Housing
MoldedPC/ABShandleandbatterycup
Power Requirements
2 “AA” size alkaline or rechargeable batteries
Battery Life
upto8hours(alkaline)
Working Range(LineofSight)
100m(300ft)
Note:ActualrangedependsonRFsignalabsorption,re-
flectionandinterference.
RF Carrier Range
H6:524–542MHz,30mW
J6:572.250–589.875MHz,30mW
K5E:606–630MHz,10mW
L5:644–662MHz,30mW
P6:702.200–719MHz,30mW
R1:800–820MHz,20mW
T1:846–865MHz,10mW
Q8:740–752MHz,10mW
JB:806–810MHz,10mW
R14:794–806MHz,20mW
X5:925–932MHz,10mW
G4:470.125–493.825MHz,30mW
G8:494.200–509.825MHz,30mW
Note: varies by region
Audio Frequency Response
45–15000Hz
Note:Dependentonmicrophonetype
Total Harmonic Distortion(Ref.±33kHzdeviation,1kHz
tone)
0.5%,typical
Dynamic Range
>100dB,A-weighted
Operating Temperature Range
-18°C(0°F)–+50°C(122°F)
Note:Batterycharacteristicsmaylimitthisrange.
Transmitter Audio Polarity
Positive pressure on microphone diaphragm (or positive
voltageappliedtotipofWA302phoneplug)produces
positivevoltageonpin2(withrespecttopin3oflow-
impedanceoutput)andthetipofthehighimpedance1/4-
inch output.
PGX4 Wireless Receiver
Dimensions
40mmX181mmX104mm(HxWxD)
Weight
327g(11.5oz.)
Housing
ABS
Sensitivity
-105dBmfor12dBSINAD,typical
Image Rejection
>70dB,typical
Power Requirements
12–18VDC@150mA,suppliedbyexternalpowersupply
(tip positive)
Audio Output
Configuration
Impedance balanced
Audio Output Level(Ref.±33kHzdeviationwith1kHztone)
XLRconnector:–19dBV(into600Ωload)
6.35mm(1/4”)connector:–5dBV(into3kΩload)
Impedance
XLR:200Ω
6.35mm(1/4”):1kΩ
Pin Assignments
XLR: 1=ground,2=hot,3=cold
6.35 mm (1/4”) TRS: Tip=audio,Ring=noaudio,
Sleeve=ground
NOTE:
ThisRadioequipmentisintendedforuseinmusical
professionalentertainmentandsimilarapplications.
ThisRadioapparatusmaybecapableofoperating
onsomefrequenciesnotauthorizedinyourregion.
Please contact your national authority to obtain
informationonauthorizedfrequenciesandRF
powerlevelsforwirelessmicrophoneproducts.