Need help?Do you have a question about the Shure QLXD1 and is the answer not in the manual?
General| Form factor | Bodypack transmitter |
|---|---|
| Built-in display | Yes |
| Operating frequency | 20 - 20000 MHz |
| Signal-to-Noise Ratio (SNR) | 20 dB |
| Battery type | AA |
| Number of batteries supported | 2 |
Instructions for safe operation, including water, cleaning, ventilation, and heat.
Explanation of polarized and grounding plugs for electrical safety.
Information on ministerial licenses and user responsibility for operating the equipment.
Description of the system's transparent 24-bit audio, wide frequency response, and RF efficiency.
Connect power supply and antennas to the receiver for initial setup.
Procedure to scan for and select the best available receiver channel.
Instructions for accessing battery compartments and installing batteries.
Steps to synchronize transmitter and receiver for an audio channel via IR.
Performing sound checks and adjusting gain levels for optimal audio.
Details on Shure's rechargeable battery, charging, and care.
Methods for tuning receiver and transmitter to the same frequency.
Using scan and IR sync to automatically create an audio channel.
Automating frequency assignment across networked receivers.
Linking two transmitters to a receiver and performing IR sync.
Adjusting transmitter power for optimal range (Lo/Hi settings).
Common network issues and solutions for connectivity problems.
Manually configuring IP addresses and subnet masks on the receiver.
Ensuring consistent operation by matching firmware versions across devices.
Process for obtaining and installing firmware updates using Shure Update Utility.
Procedure for updating firmware on both receiver and transmitter units.
Identifies common system issues and provides solutions.
Techniques to minimize radio frequency interference for better performance.
Explanation of error codes and procedures for resolving them.
Table detailing frequency bands and transmitter output power levels.
To Next Page
