Shure SM7dB - Installation and Specifications; Install or Remove the Stand Adapter; Microphone Specifications

Shure Incorporated
8/12
Install or Remove the Stand Adapter
To mount the microphone on a 3/8 in. stand, insert the included brass stand adapter and tighten it with a coin or screwdriver.
Important: Make sure that the slots on the adapter face outward.
Specifications
Type
Dynamic (moving coil)
Frequency Response
50to20,000Hz
Polar Pattern
Cardioid
Output Impedance
Preamp engaged 27Ω
Bypass mode 150Ω
Recommended Load
>1kΩ