Shure ULX-D Series - Transmitter Configuration and Synchronization; Changing Transmitter Settings Overview; Wireless Workbench and Docking Station Setup

Shure Incorporated
13/23
•
•
•
•
•
•
•
•
•
•
•
1.
2.
3.
4.
Battery Life 10mW
1:45 to 0:45
0:45 to 0:15
0:15 to 0:00
Changing Transmitter Settings
Each transmitter has the following adjustable settings:
Mute button and mute LED behavior or brightness
High-pass filter
RF power
Power lock
Initial state from charger
Battery type
Device name
Channel name
Frequency
Normal or High-Density mode
Boundary and gooseneck offset
There are three ways to change transmitter settings:
Wireless Workbench and Networked Docking Station (recommended)
Required equipment: Networked docking station, computer with Wireless Workbench installed, and transmitter
Place transmitters on charger. Check that charger is connected to network and to Wireless Workbench.
Open the Item Properties for the charger in Wireless Workbench.
Select one or multiple transmitters.
Make changes to transmitter settings and click Apply. Transmitters are now ready to use.