Shure ULX-D Series - Wireless Workbench and IR Synchronization; Receiver Front Panel Configuration

Shure Incorporated
14/23
1.
2.
3.
4.
1.
2.
3.
4.
5.
•
Wireless Workbench and IR Sync
Required equipment: Computer with Wireless Workbench installed, receiver, and transmitter
Ensure that the receiver is connected to the network and to Wireless Workbench.
From Wireless Workbench, access the Properties Panel for the receiver.
Navigate to IR Presets and set the transmitter parameters.
Sync the transmitter and receiver to send the settings to the transmitter.
Receiver Front Panel
Required equipment: Receiver and transmitter
Use receiver front panel and control wheel to change transmitter settings. See receiver user guide for detailed menu
structure.
Press enter on receiver to save changes.
Press sync.
Align the receiver and transmitter IR windows until the receiver IR window illuminates red.
When complete, SYNC SUCCESS! appears.
Note: If using a QLX-D receiver, you must use Wireless Workbench to make changes to transmitter settings.
Using QLX-D with a Shure ULX-D System
Transmitters and receivers from QLX-D and ULX-D component groups can be paired to form audio channels.
To ensure functionality, use the following settings on receivers and transmitters:
Encryption set to Off