flow rate even if there is “no-flow” in the pipeline. If the value consistently present, double-
check the pipe leakage and then reset the offset if you are sure there is no leakage or flow.
h) This will conclude the installation.
Cautions
a) Don't alter any parts of the product.
b) Ensure the electrical connection is properly done per the instructions.
c) Make sure no mechanical stresses in the connections.
d) The strong electromagnetic interference sources close by or any mechanical shocks at the
pipeline may also create malfunctioning of the product.
e) Slowly open/close valves at the gas supply piping to prevent abrupt pulse flow impact.
To Next Page
Loading...
