2. Receipt / unpack of the products
Upon receipt of the products, please check the packing box before the dismantlement of the packing
materials. Ensure no damages during shipping. If any abnormality is observed, please contact and
notify the carrier who shipped the product and inform the distributors or sales representatives if the
order is not placed directly with the manufacturer, otherwise, the manufacturer should be informed
as well. For any further actions, please refer to the return and repair section in this manual.
If the packing box is intact, proceed to open the packing box, and you shall find the product (either
the meter with LED display or the sensor without the display per the actual order). The power and
data cable as shown below may also be found according to the same packing materials.
Figure 2.1: MF/FS4o00 flow meter Figure 2.2: data cable
Please check immediately for the integrity of the product as well as the power and data cable, if any
abnormal is identified, please notify the distributor/sales representative or manufacturer as soon as
you can. If any defects are confirmed, an exchange shall be arranged immediately via the original
sales channel. (Note: the LED display shall not be lighted up until the power cable is plugged in). This
user manual shall also either be included in the packing box or via an online request for an electronic
version. In most cases, this manual shall be made available to the customer before the actual order.
The standard cable has an AMPMODU MTE (5 positions) compatible connector with a length of 0.5
meters.
To Next Page
Loading...
Need help?
General
