2. Receipt / unpack of the products
Upon receipt of the products, please check the packing box before the dismantlement of the packing
materials. Ensure no damages during shipping. If any abnormality is observed, please contact and
notify the carrier who shipped the product and inform the distributors or sales representatives if the
order is not placed directly with the manufacturer, otherwise, the manufacturer should be informed
as well. For any further actions, please refer to the return and repair section in this manual.
If the packing box is intact, proceed to open the packing box, and you shall find the product (either
the meter or the meter with valve per the actual order). The power adapter and/or data cable as
shown below may also be found according to your actual order.
or
Flow meter Flow sensor + valve Adapter data cable
Figure 2.1: MF5700 flow meter and accessories
Please check immediately for the integrity of the product as well as the power and data cable, if any
abnormal is identified, please notify the distributor/sales representative or manufacturer as soon as
you can. If any defects are confirmed, an exchange shall be arranged immediately via the original
sales channel. (Note: the LCD screen shall not be lighted until the battery is installed or the power
cable is plugged in). This user manual shall also either be included in the packing box or via an online
request for an electronic version. In most cases, this manual shall be made available to the customer
before the actual order.
The meter is designed with low power that can be operated with 4 AA-batteries. However, if you
ordered the product with the control valve, it is recommended to have external power since the valve
requires large power consumption. A power adapter must have a safety certification for use with this
meter. The external power/data connector is a type-C USB. See the detailed requirements in the
operation section.
To Next Page
Loading...
Need help?
General
